User`s guide
Copyright © 2014 congatec AG IGX1m02 87/134
Standard Parallel
Port Mode The standard mode will be used for the parallel port.
EPP Mode
Fast transfer mode (up to 2 MByte/sec), data output and data reception are
possible. The mode requires a
peripheral device which supports the EPP
(Enhanced Parallel Port) mode.
ECP Mode
Fast transfer mode (up to 2.4 MByte/sec), data output and data reception are
possible. The mode requires a
peripheral device which supports the ECP
(Extended Capability Port) mode. The necessary DMA channel is
determined
by the system.
EPP Mode & ECP
Mode Both transfer modes are available.
17.13 Network Stack
Species whether the UEFI Network Stack is available for network access under UEFI. If the
UEFI Network Stack is disabled, UEFI installation
via PXE is not possible, for example.
Disabled
The UEFI Network Stack is not available.
Enabled
The UEFI Network Stack is available.
17.13.1 Ipv4 PXE Support
Species whether PXE UEFI Boot via Ipv4 is available for installation of
operating systems in UEFI mode.
Disabled PXE UEFI Boot via Ipv4 is not available.
Enabled PXE UEFI Boot via Ipv4 is available.
17.13.2 Ipv6 PXE Support
Species whether PXE UEFI Boot via Ipv6 is available for installation of
operating systems in UEFI mode.
Disabled PXE UEFI Boot via Ipv6 is not available.
Enabled PXE UEFI Boot via Ipv6 is available.