User`s guide
Copyright © 2014 congatec AG IGX1m02 50/134
7.11 Intrusion Connector
Pin Signal
1 GND
2 Case open (low asserted)
3 Intrusion switch present (low asserted)
Note
The intrusion supervision feature needs to be enabled in BIOS Setup rst (Menu “Security”/”Cabinet
Monitoring”). This BIOS option is only available if pin 3 (“Intrusion Switch Present”) is connected to
GND.
Chassis intrusion is active even if the system is switched off (S5 state) or disconnected from mains power. The intrusion event is monitored by
the chipset and stored in the BIOS Eventlog during the next Boot. A
timestamp (Boot date/time) will be added then.
Note
This timestamp does not represent date/time of the intrusion event.
If a Supervisor Password is enabled in BIOS Setup, the system will stop during BIOS POST if an intrusion event has been detected. In order
to continue, the Supervisor Password must be entered to conrm the intrusion event.
The intrusion status can be easily monitored by using the BMCAPI (Windows)
Drive Power
COM 3
LPT
Front Panel
Mouse
Keyboard
Power
COM 2
DisplayPort
PCIe X4
FAN 2
1
2
Front Panel 1 = HDD_LED+
2 = Power_LED+
3 = HDD_LED-
4 = Power_LED-
5 = Reset_Switch
DC Plug Jumper Settings1 = + DC
2 = GND
12 V max. 60 Watt
19-24 V max. 100 Watt
Plug: 2.5 / 5.5 / 11 mm
Power 1 = GND
2 = GND
3 = + DC 12 / 19-24 V
4 = + DC 12 / 19-24 V
6 = Power_Switch
7 = Reset_Switch
8 = Power_Switch
9 = Reserved
Drive Power 1 = Vcc 5 V max. 2 A
2 = GND
3 = GND
4 = +12 V max. 2 A
FAN 1
SPDIF
Front Audio
mini PCIe
mSATASATA0 SATA1
LAN
2x USB 2.0
LAN
2x USB 2.0
LVDS
Backlight
TPM GPIO
Buzzer
Battery
2x USB 3.0
2x USB 2.0
LVDS
CPU
Memory Module 1
Memory Module 2
BIOS Recovery Settings
LVDS Supply Settings
USB 2.0
LVDS BL Control Settings
System Power On Settings
1
1
Fan 1 (CPU)
1 = GND
2 = 12 V PWM mode, 4..12 V 3-pin mode
3 = Sense
4 = PWM
1
Fan 2 (Chassis)
4
2
3
2
1
DC DVI-I DisplayPort
COM1 COM2
BIOS Recovery Settings
Normal Operation (default)
Normal Operation (default)
LVDS Supply Settings
LVDS BL Control Settings
System Power On Settings
Always on
BIOS Recovery / Reset to Defaults
VCC 3.3 V
(default)
VCC 5 V
Analog
(default)
PWM