User`s guide

3.8 Heatsink Installation Notes

Mounting backplate (included with heatsink):

Assembly Notes:

• Hold the heatsink with one hand so that it does not tilt while tightening the screws

• Slightly tighten each of the 4 screws so that they hold the heat sink in place. To do so, start with one screw and then slightly tighten the

other screws using a crossover pattern, all the while keep holding the heat sink straight with one hand.

• Now you can fully tighten the screws. Once again start with one and then continue to tighten the other screws using a crossover pattern,

all the while keep holding the heat sink straight with one hand.

Caution

Insulating foil of backplate must NOT be removed, otherwise the conga-IGX may be damaged due to a possible short circuit.

Note

Recommended torque for heatsink screws: 0.6Nm