User`s guide
Copyright © 2008 congatec AG B915m10 88/92
Power Setup9.7
Select the Power tab from the setup menu to enter the Power Management setup screen.
Feature Options Description
Power Management / APM Disabled
Enabled
Set this option to allow or prevent chipset power management and APM (Advanced Power Management).
Suspend Timeout Disabled
1- 60 Min
Species the length of time of inactivity the system waits before it enters suspend mode.
Video Power Down Mode Disabled
Standby
Suspend
Species the power state that the video subsystem enters when the BIOS places it in a power saving state after the
specied period of display inactivity has expired.
Hard Disk Power Down Mode Disabled
Standby
Suspend
Species the power state that the hard disk drives enter after the specied period of hard drive inactivity has expired.
<Device> Ignore
Monitor
Determines whether the device activity is monitored by the power management timer or not.
Resume On Ring Disabled
Enabled
Disable / enable RI signal (= GPE2 on pin 89 of X4 connector) to generate a wake event.
If enabled wake is possible from all power down states including S5 (Soft Off).
Resume On PME Disabled
Enabled
Disable / enable PCI PME to generate a wake event.
If enabled wake is possible from all power down states including S5 (Soft Off).
Resume On RTC Alarm Disabled
Enabled
Disable / enable RTC to generate a wake event.
If enabled wake is possible from all power down states including S5 (Soft Off).
RTC Alarm Date (Days) Everyday, 01....31 Select the day of the month when the event should be generated.
System Time Hour:Minute:Second Select the system time when the event should be generated.
Power Button Mode On/Off
Suspend
Species if the system enters suspend or soft off mode when the power button is pressed.
Exit Menu9.7.1
Select the Exit tab from the setup menu to enter the Exit setup screen.
You can display an Exit screen option by highlighting it using the <Arrow> keys.
Feature Description
Save Changes and Exit Exit setup and reboot so the new system conguration parameters can take effect.
Discard Changes and Exit Exit setup without saving any changes made in the BIOS setup program.
Discard Changes Discard changes without exiting setup. The option values presented when the computer was turned on are used.
Load CMOS Defaults Load the CMOS defaults of all the setup options.