User`s guide

ManualsBrandsCongatec ManualsComputer equipmentCOM Express conga-B915

Remote Access Conguration Submenu9.4.11

Feature Options Description

Remote Access Disabled

Enabled

Enable/Disable the BIOS remote access feature.

Note: If the systems serial ports are disabled in the ‘I/O Interface Conguration’ submenu, then Serial Redirection is disabled and

‘Remote Access Conguration’ menu is unavailable to the users.

Serial Port Number COM1

COM2

Select the serial port you want to use for console redirection.

Note: Only enabled serial ports are presented as an option.

Serial Port Mode 115200 8,n,1

57600 8,n,1

19200 8,n,1

Select the baud rate (transmitted bits per second) you want the serial port to use for console redirection.

Note: The terminal program used with Serial Redirection must be set to use exact the same set of communication parameters.

Flow Control None

Hardware

Software

Select the ow control for Serial Redirection.

Redirection After BIOS

POST

Disabled

Boot Loader

Always

With Disabled Serial Redirection functionality is disabled at the end of BIOS POST.

If set to Always, all resources and interrupts associated with Serial Redirection are protected and not released to DOS. This option

lets Serial Redirection permanently reside at base memory, which allows the DOS console to be redirected.

Note that the graphics output (VGA, SVGA, etc) from DOS programs is not redirected.

If set to Boot loader, Serial Redirection is active during the OS boot loader process. This allows boot status messages to be

redirected, but Serial Redirection will terminate when the OS loads.

Terminal Type ANSI

VT100

VT-UTF8

Select the target terminal type.

Escape sequences representing keystrokes are sent to the remote terminal based on these settings.

VT-UTF8 Combination

Key Support

Disabled

Enabled

This option enables VT-UFT8 combination key support for ANSI/ VT100 terminals.

Sredir Memory Display

Delay

No Delay

Delay 1 Sec

Delay 2 Sec

Delay 4 Sec

Set the delay in seconds to display memory information if serial redirection is enabled.

Serial Port BIOS Update Disabled

Enabled

Enable or disable the serial port BIOS update feature. Disabling saves boot time.

Note

This setup node is only applicable if an external Super I/O has been implemented on the carrier board.