Installation Guide

4
#6: Place hinge (barrel side up) over the mortised area
on the 3” support. Attach using 2 - #10 x 3/4”
self-tapping screws through the indents on the
support. It is not necessary to drill pilot holes.
Repeat to attach second hinge.
*NOTE*: HINGES MUST BE INSTALLED BARREL
SIDE UP FOR STEP TO CLOSE PROPERLY
#8: Stand the step up on the front edge. While
holding, have your helper place the hinged top
assembly support over the locking tabs on back
of the step. Tap down until seated onto the
locking tabs.
#7: Position the second tread on a at surface bottom
side up. Place the hinges over the mortised area
on the treads and attach using 2 - #10 x 3/4”
self-tapping screws in each hinge.
#10: Place storage liner into step.#9: Pre-drill 1/8” pilot holes in the two marked
locations at the ends of the 3” support. Attach
support using 2 - #10 x 1-1/4” self-tapping
screws.