Installation Guide

ManualsBrandsConfer ManualsHome Spas36 in. Storage Step, 2 Tone Deep in Gray and Black

THE STORAGE STEP

Parts List

2 - 36” Treads

1 - 7” Support

1 - 5” Support

1 - 3” Support

1 - Storage Liner

2 - Sidewalls

Hardware Pack

2 - Stainless Steel Hinges

1 - 1 Foam Strip (4 pads)

4 - #10 x 1-1/4” self-tapping screws

8 - #10 x 3/4” self-tapping screws

Tools Needed

Rubber Mallet

Cordless Drill

1/8” Drill Bit

#2 Phillips head driver

If missing parts call - Toll free U.S./Canada - 800-635-3213 or www.conferplastics.com

Hinge Top Assembly

(assembly required)

3” Support

Sidewalls

5” Support

7” Support

Storage Liner

36” Tread

Safe Installation

To reduce the risk of drowning, electrocution, falls, or other serious injury or death:

Check building codes/permitting - Consult your local Building Department before

installation of your step and equipment. Equipment installation must comply with the codes of the authority having

jurisdiction and may require permits (e.g., building, plumbing, electrical, zoning, etc.). Be sure that barriers (fences,

gates, etc.) restricting spa access meet local codes.

Use for intended purpose only - Not intended for storing hazardous products (e.g., chemicals) - the step is not a

secure location.

Check that you have all required parts - Check the contents of the carton with the Parts List for this step. All parts

and hardware are required. If any parts are missing DO NOT attempt to assemble or install the step. Instead call Toll

Free U.S. 800-635-3213 or visit our website at www.conferplastics.com for assistance.

Select an appropriate location - The step must be located on a level solid base and in a location that will be in full view

of competent adult supervision when in use.

- Follow all instructions.

• For stable correct assembly and installation all instructions must be followed completely and in the sequence shown.

• Follow the manufacturer’s recommendations for the safe use of all hand tools and equipment used during installation.

Cordless drill only. No corded drills near water - Use a cordless drill for assembly and installation. To reduce the risk

of electrocution, NEVER use a corded drill in or around a water.

Lift safely - When lifting awkward or heavy loads, have another person help you.

Double check after installation -

• Before using the product, after assembly and installation, go over the instructions and procedures again to make sure

nothing has been overlooked.