Installation Guide

ManualsBrandsConfer ManualsHome Spas36 in. Storage Step, 2 Tone Deep in Gray and Black

THE STORAGE STEP

By Confer Plastics

WEIGHT LIMIT 300 LBS.

ASSEMBLY, INSTALLATION AND USE MANUAL

Assembly video available online: www.conferplastics.com

To reduce the risk of drowning, falls, paralysis, electrocution, or other serious

injury or death:

Dealer/Installer: Give manual to homeowner.

Installer: Read “Safe Installation” on page #2 and all instructions before beginning. For proper assembly

and installation, instructions must be followed completely.

Homeowner: Read “Safe Use” on back cover before using. Save these instructions.

Installation must comply with local codes and may require permits.

MADE IN U.S.A. BY

MODEL #LASS36-SC

Scan to

see our

Installation

Videos

Summary of content (6 pages)

PAGE 1
To reduce the risk of drowning, falls, paralysis, electrocution, or other serious injury or death: Dealer/Installer: Give manual to homeowner. Installer: Read “Safe Installation” on page #2 and all instructions before beginning. For proper assembly and installation, instructions must be followed completely. Homeowner: Read “Safe Use” on back cover before using. Save these instructions. Installation must comply with local codes and may require permits.
PAGE 2
THE STORAGE STEP If missing parts call - Toll free U.S./Canada - 800-635-3213 or www.conferplastics.
PAGE 3
PAGE 4
STEP ASSEMBLY: WARNING! Using a corded drill near spa may result in electrocution. #1: Install 2 self-adhesive pads on each of the sidewalls. #2: Pre-drill 1/8” pilot holes in the two marked locations at the end of the 5” support. #3: With a helper, place the 5” support over the two locking tabs on the sidewalls. Tap down with mallet until seated on the locking tabs. Secure the support at both ends using 2 - #10 x 1-1/4” screws.
PAGE 5
#6: Place hinge (barrel side up) over the mortised area on the 3” support. Attach using 2 - #10 x 3/4” self-tapping screws through the indents on the support. It is not necessary to drill pilot holes. Repeat to attach second hinge. *NOTE*: HINGES MUST BE INSTALLED BARREL SIDE UP FOR STEP TO CLOSE PROPERLY #7: Position the second tread on a flat surface bottom side up. Place the hinges over the mortised area on the treads and attach using 2 - #10 x 3/4” self-tapping screws in each hinge.
PAGE 6
Safe Use To reduce the risk of drowning, falls, paralysis, electrocution, or other serious injury or death: Use step system properly. Use for intended purpose only - Not intended for chemical storage. • No diving or jumping from steps - shallow water; risk of paralysis or death. • ONE PERSON ON THE LADDER/STAIR AT A TIME. • Illuminate the steps when using the spa at night. Weight limit - 300 lbs. maximum - Exceeding maximum weight may cause the step to fail.