User`s guide

Conexant RCV56 HSF User’s Guide
59
z
Make sure that your phone line is connected to your PHONE jack of the modem
interface.
z
The telephone you are using to connect will ring if you try to call from another
phone line.
z
Configured the modem to an Auto-answer modem.
z
Send AT S0=n to modem where n is the number of incoming rings and check
light AA is on.
If no connection was shown after modem was dialed out
z
Remote modem might not set to answer mode, if you do not hear a high-pitch
tone when you make a call.
z
Perhaps you get a poor-quality or noisy telephone lines, wait to try another call.
If there was an Data error when making the connection
z
Make sure that your software data format is matched to remote side (for example:
8,N, 1).
z
Make sure the modem flow control method is matched to communication
application.
z
Try to connect later, maybe you get a poor-quality or noisy telephone lines.
Fax and voice problems
z
Be sure that the Data Communication is installed and performed properly;
otherwise, check the previous procedures carefully and follow the Fax/Voice
manual step by step.