User`s manual

(1-4):
Flashing
OFF
Tx or Rx activity
No Link
These four LAN (Local Area Network) ports are where you will connect
networked devices, such as PCs, print servers, remote hard drives, and
anything else you want to put on your network.
2.3 The Rear Ports
Connector Description
POWER:
Power connector with 9Vdc/ 1.5 Ampere
Reset Switch
The reset button, when pressed, resets the modem without the need to
unplug the power cord
LAN (1-4):
Router is successfully connected to a device through the corresponding
port (1, 2, 3 or 4). If the LED is flashing, the Router is actively sending or
receiving data over that port.
ADSL Connector:
The RJ-11 connector allows data communication between the modem and
the ADSL network through a twisted-pair phone wire
2.4 Hardware installation
This section describes how to connect and configure the ADSL router.
Step 1. Connect the ADSL Line