User`s manual

3.3.20 Admin Privilege - ADSL Configuration
The ADSL Configuration page allows the user to set the configuration for ADSL protocols.
• Trellis: This field allows the user to enable or disable the Trellis Code. By default, it is
always enabled.
• Handshake Protocol: This field allows the user to select the ADSL handshake protocol.
• Wiring Selection: This field allows the user to enter the wiring selection for the RJ-11.
Tip/Rip is the default for the board without the inner/outer pair relay
• Bit Swapping: This field allows the user to enable or disable the upstream bit swapping.
• Annex Mode Config: This field allows the user to set auto detected or user selected
annex mode of hardware.