User's Manual

ISL37704C Indigo Cardbus manual (preliminary) rev. 2
Page 2 of 2
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in
accordance with the instructions, it may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and correct the
interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the distance between the equipment and the receiver.
3. Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Export restrictions:
This product or software contains encryption code which may not be exported or transferred from the
US or Canada without an approved US Department of Commerce export license.
FCC Guidelines for Human Exposure
SAR (Specific Absorption Rate) for this device was measured in accordance with FCC OET Bulletin 65
(Supplement C) and guidelines established in IEEE C95.1-1991. Based on these measurements, this
device fulfills the SAR limits for general population / uncontrolled exposure
Caution:
In order to comply with RF exposure limits established in the ANSI C95.1 standards, the user is advised
to maintain a distance of at least 1.0 cm from the antenna of this device while it is in use.
If the antenna is positioned less than 1.0 cm from the user, it is recommended that the user limits the
exposure time.
Europe - EU R&TTE Declaration of Conformity
This Wireless LAN Radio device is tested to and conforms with the essential radio test suites included in
following standards:
Standard Description and Explanation
LVD specification
EN 60950
EN 60950,ed. (1992), incl. A1(1993), A2(1993), A3(1995) and
A4(1997)
Safety of information technology equipment, including electrical
business
equipment.
Meets R&TTE directive art. 3.1.a of essential requirements on
protection
of the health and safety of the user.
ETSI EMC specification
ETSI EN 301 489
Part 1 V1.2.1 (2000-08)
Part 17 V1.1.1 (2000-09)
Electromagnetic compatibility and Radio spectrum Matters (ERM);
Electromagnetic Compatibility (EMC) standard for radio equipment
and services;
Part 1: Common technical requirements
Part 17: Specific conditions for Wideband data and HIPERLAN
equipment
ETSI RF specification
EN 301 893
Broadband Radio Access Networks (BRAN), HIPERLAN Type 2
Harmonised EN covering essential requirements of article 3.2 of