User's Manual

6
All Intersil products are manufactured, assembled and tested utilizing ISO9000 quality systems.
Intersil Corporation’s quality certifications can be viewed at website www.intersil.com/design/quality
Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design and/or specifications at any time without notice. Accordingly, the
reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be accurate and reliable. However, no responsibility is assumed
by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise
under any patent or patent rights of Intersil or its subsidiaries.
For information regarding Intersil Corporation and its products, see web site www.intersil.com
Sales Office Headquarters
NORTH AMERICA
Intersil Corporation
2401 Palm Bay Rd.
Palm Bay, FL 32905
TEL: [phone]
FAX: [phone]
EUROPE
Intersil SA
Mercure Center
100, Rue de la Fusee
1130 Brussels, Belgium
TEL: [phone]
FAX: [phone]
ASIA
Intersil Ltd.
8F-2, 96, Sec. 1, Chien-kuo North,
Taipei, Taiwan 104
Republic of China
TEL: [phone]
FAX: [phone]
EIRP EIRP @ -30 dB 1st Side Lobes - 18.7 - dBm
Receive Sensitivity RX_S 1Mbps, 8% PER - -93 - dBm
2Mbps, 8% PER - -90 - dBm
5.5Mbps, 8% PER - -89 - dBm
11Mbps, 8% PER - -85 - dBm
Multipath Delay Spread
using IEEE 802.11 Naftali Model
(T
Delay
) 2Mbps, 8% PER <290 nSec
5.5Mbps, 8% PER 200 nSec
11Mbps, 8% PER 105 nSec
Multipath Receive Sensitivity RX_S
JTC
5.5Mbps, 8% PER JTC Commercial A - TBD - dBm
11Mbps, 8% PER JTC Residential A - TBD - dBm
Maximum Receive Level RX_MAX PER <8% (11 Mbps) - >10 - dBm
Third Order Intercept Point (Input) IIP3_90 -90 dBm input - TBD - dBm
IIP3_25 -25 dBm input - TBD - dBm
Carrier Suppression TX_sup Test Mode -45 -40 -34 dB
Image Rejection IR PER <8% - 45 - dB
IF Rejection IFR PER <8% >84 - dB
Adjacent Channel Rejection ACR PER <8% (Note 6), 11Mbps signal w/
11 Mbps jammer 25 MHz offset
52.5 53 53.9 dB
Data Rate (Physical Layer) Rate - 1, 2, 5.5
and 11
-Mbps
5. The adjacent channel measurement is carried out on two channels separated by 25MHz (5 channels).
6. Refer to application Note “PRISM Power Management Modes” [4]
Electrical Specifications Test Conditions: Supply Voltage (V
CC
) = 3.3V, Ambient Temperature (T
A
)=25
o
C,
Unless Otherwise Specified (Continued)
PARAMETER SYMBOL TEST CONDITIONS MIN TYP MAX UNITS
FN8026