User's Manual

6
All Intersil products are manufactured, assembled and tested utilizing ISO9000 quality systems.
Intersil Corporation’s quality certifications can be viewed at www.intersil.com/design/quality
Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design and/or specifications at any time without notice.
Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be accurate and reliable.
However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third parties which may result from its
use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries.
For information regarding Intersil Corporation and its products, see www.intersil.com
Sales Office Headquarters
NORTH AMERICA
Intersil Corporation
7585 Irvine Center Drive
Suite 100
Irvine, CA 92618
TEL: [phone]
FAX: [phone]
Intersil Corporation
2401 Palm Bay Rd.
Palm Bay, FL 32905
TEL: [phone]
FAX: [phone]
EUROPE
Intersil Europe Sarl
Ave. C - F Ramuz 43
CH-1009 Pully
Switzerland
TEL: [phone]
FAX: [phone]
ASIA
Intersil Corporation
Unit 1804 18/F Guangdong Water Building
83 Austin Road
TST, Kowloon Hong Kong
TEL: [phone]
FAX: [phone]
Multipath Receive Sensitivity Using JTC
Models (note 5.)
RX_S
JTC
1Mbps,8%PER,JTC
Commercial B (150 nsec)
-82 dBm
2Mbps,8%PER,JTC
Commercial B (150 nsec)
-80 dBm
5.5 Mbps, 8% PER, JTC
Commercial B (150 nsec)
-76 dBm
11 Mbps, 8% PER, JTC Office B
(100 nsec)
-67 dBm
Maximum Receive Level RX_MAX PER <8% +3 dBm
Third Order Intercept Point (Input) IIP3_90 -90 dBm input -3 dBm
IIP3_25 -25 dBm input 20 dBm
Carrier Suppression TX_sup Test Mode 42.5 dB
Image Rejection IR PER <8% 60 dB
Adjacent Channel Rejection ACR PER <8% (Note 6) 46 dB
Data Rate (Physical Layer) Rate 1, 2, 5.5
and 11
Mbps
NOTES:
5. For more information, refer to Intersil Application Note AN9895 “Multipath Measurement in Wireless LANs”
6. The adjacent channel measurement is carried out on two channels separated by 25MHz (5 channels).
Electrical Specifications Test Conditions: Supply Voltage (V
CC
) = 3.3V, Ambient Temperature (T
A
)=25
o
C,
Unless Otherwise Specified (Continued)
PARAMETER SYMBOL TEST CONDITIONS MIN TYP MAX UNITS
ISL37101P-EVAL