User Manual
Table Of Contents
- Contents
- 1 Getting started
- 2 Installing the Access Point
- 3 Configuring the Access Point
- 3.1 Introduction
- 3.2 When to configure the Access Point
- 3.3 Starting the Web Interface
- 3.4 Launching Web Interface manually
- 3.5 Contents of Web Interface
- 3.5.1 Settings Summary
- 3.5.2 Wireless Settings
- 3.5.3 Security against unauthorized network access
- 3.5.4 To add a a client to the exception list
- 3.5.5 To delete a client from the exception list
- 3.5.6 Security against eavesdropping
- 3.5.7 Change WEP password
- 3.5.8 Security against unauthorized configuration
- 3.5.9 Identity
- 3.5.10 IP Settings
- 4 Troubleshooting
- 5 Technical specifications 11 Mbps WLAN Access Point
- 6 Regulatory notes and statements
- 6.1 Wireless LAN, Health and Authorization for use
- 6.2 Regulatory Information/disclaimers
- 6.3 USA-FCC (Federal Communications Commission) statement
- 6.4 FCC Radio Frequency Exposure statement
- 6.5 FCC Interference Statement
- 6.6 Export restrictions
- 6.7 Europe - EU R&TTE Declaration of Conformity
- 6.8 Restricted Wireless LAN device use in EU
- A TCP and IP settings
- B Wireless LAN
- Index
40
preliminary 3
Troubleshooting
If KickStart does not find the Access Point you are looking for
4.1.2 Problems on the wired side
Always check if your cables and connections are in good order and
properly installed.
Is there a network connection? Check the network LED.
The Access Point may take up to
a minute to find an IP address it
can use if Auto IP is used to
assign an IP address.
Client cannot make connection A wireless client is not (yet)
connected to the Access Point.
Refer to the manual of the
wireless client on how to connect.
Table 4-1 Troubleshooting the wireless connection of an
Access Point (vervolg)
Possible cause Solution
Table 4-2 Troubleshooting the wired connection of an Access Point
Possible cause Solution
Has the proper cable been used? • If the Access Point is
connected to a hub, a ‘normal’
(not a crosswired) cable must
be used,
• If the Access Point is
connected directly to a
computer, a crosswired cable
must be used.