User Manual
Table Of Contents
- Contents
- 1 Getting started
- 2 Installing the Access Point
- 3 Configuring the Access Point
- 3.1 Introduction
- 3.2 When to configure the Access Point
- 3.3 Starting the Web Interface
- 3.4 Launching Web Interface manually
- 3.5 Contents of Web Interface
- 3.5.1 Settings Summary
- 3.5.2 Wireless Settings
- 3.5.3 Security against unauthorized network access
- 3.5.4 To add a a client to the exception list
- 3.5.5 To delete a client from the exception list
- 3.5.6 Security against eavesdropping
- 3.5.7 Change WEP password
- 3.5.8 Security against unauthorized configuration
- 3.5.9 Identity
- 3.5.10 IP Settings
- 4 Troubleshooting
- 5 Technical specifications 11 Mbps WLAN Access Point
- 6 Regulatory notes and statements
- 6.1 Wireless LAN, Health and Authorization for use
- 6.2 Regulatory Information/disclaimers
- 6.3 USA-FCC (Federal Communications Commission) statement
- 6.4 FCC Radio Frequency Exposure statement
- 6.5 FCC Interference Statement
- 6.6 Export restrictions
- 6.7 Europe - EU R&TTE Declaration of Conformity
- 6.8 Restricted Wireless LAN device use in EU
- A TCP and IP settings
- B Wireless LAN
- Index
555004.doc
33
Configuring the Access Point Contents of Web Interface
(see Figure 3-8).
If you selected “Allow access to all clients, you can type the MAC
address of the client that you want to deny access to in the field
MAC
Address
.
If you selected “Deny access to all clients, you can type the MAC
address of the client that you want to allow access to in the field
MAC
Address
.
2. Then click on the button
OK
. The client is now added to the exception
list.
3.5.5 To delete a client from the exception list
Follow these steps to add a client to the exception list (see section):
1. Click on the button
Delete clients
. A separate window opens in
which the Exception list is displayed (see Figure 3-9). .
Figure 3-8 Web Interface dialog window: Add client
Figure 3-9 Web Interface dialog window: Delete clients