User Manual
Table Of Contents
- Contents
- 1 Getting started
- 2 Installing the Access Point
- 3 Configuring the Access Point
- 3.1 Introduction
- 3.2 When to configure the Access Point
- 3.3 Starting the Web Interface
- 3.4 Launching Web Interface manually
- 3.5 Contents of Web Interface
- 3.5.1 Settings Summary
- 3.5.2 Wireless Settings
- 3.5.3 Security against unauthorized network access
- 3.5.4 To add a a client to the exception list
- 3.5.5 To delete a client from the exception list
- 3.5.6 Security against eavesdropping
- 3.5.7 Change WEP password
- 3.5.8 Security against unauthorized configuration
- 3.5.9 Identity
- 3.5.10 IP Settings
- 4 Troubleshooting
- 5 Technical specifications 11 Mbps WLAN Access Point
- 6 Regulatory notes and statements
- 6.1 Wireless LAN, Health and Authorization for use
- 6.2 Regulatory Information/disclaimers
- 6.3 USA-FCC (Federal Communications Commission) statement
- 6.4 FCC Radio Frequency Exposure statement
- 6.5 FCC Interference Statement
- 6.6 Export restrictions
- 6.7 Europe - EU R&TTE Declaration of Conformity
- 6.8 Restricted Wireless LAN device use in EU
- A TCP and IP settings
- B Wireless LAN
- Index
555004.doc
25
Configuring the Access Point Starting the Web Interface
If you click the
Rescan
button, KickStart will search for Access Points
again. Use this e.g. to find Access Points that have just been switched
on or reset.
If the device that you want to manage is not in the list and is not found
after clicking the
Rescan
button, go to section 4.1: ‘If KickStart does not
find the Access Point you are looking for’ on page 39.
3.3.6 IP settings
In this screen you can select to either use dynamic or static IP settings.
(see chapter A: ‘TCP and IP settings’ on page 49).
Select Dynamic IP settings when you install the Access Point in a
network with a DHCP server or Auto IP.
Select Static IP settings when you want to configure the IP settings
manually.
Click on the Next button to continue to the next screen.
• If you selected the option
Use dynamic IP settings
, you will
continue to the screen Changing IP settings directly, see section
3.3.9: ‘Changing IP settings’ on page 27.
• If you selected the option
Use static IP settings
, you will
continue to the screen Set IP address of Wireless Device, see
section 3.3.7: ‘Static IP settings’ on page 26.
Figure 3-3 Screen: Change IP Settings