User Manual
Table Of Contents
- Contents
- 1 Getting started
- 2 Installing the Access Point
- 3 Configuring the Access Point
- 3.1 Introduction
- 3.2 When to configure the Access Point
- 3.3 Starting the Web Interface
- 3.4 Launching Web Interface manually
- 3.5 Contents of Web Interface
- 3.5.1 Settings Summary
- 3.5.2 Wireless Settings
- 3.5.3 Security against unauthorized network access
- 3.5.4 To add a a client to the exception list
- 3.5.5 To delete a client from the exception list
- 3.5.6 Security against eavesdropping
- 3.5.7 Change WEP password
- 3.5.8 Security against unauthorized configuration
- 3.5.9 Identity
- 3.5.10 IP Settings
- 4 Troubleshooting
- 5 Technical specifications 11 Mbps WLAN Access Point
- 6 Regulatory notes and statements
- 6.1 Wireless LAN, Health and Authorization for use
- 6.2 Regulatory Information/disclaimers
- 6.3 USA-FCC (Federal Communications Commission) statement
- 6.4 FCC Radio Frequency Exposure statement
- 6.5 FCC Interference Statement
- 6.6 Export restrictions
- 6.7 Europe - EU R&TTE Declaration of Conformity
- 6.8 Restricted Wireless LAN device use in EU
- A TCP and IP settings
- B Wireless LAN
- Index
555004.doc
35
Configuring the Access Point Contents of Web Interface
the WEP password:
1. Select the WEP method: 40 bit or 128 bit.
2. Enter a password:
WEP 40: the password must contain exactly 10 characters,
WEP 128: the password must contain exactly 26 characters.
n
Only the following alphanumeric characters are allowed in the password:
-0 to 9,
- a to f.
3. Click on OK.
3.5.8 Security against unauthorized configuration
On this page you can install a password, the so-called “Write Community
String”, that is required to make changes to the Access Point and lock
the Access Point.
To display the Security against unauthorized configuration page,
click .
1. Change Password.
Figure 3-10 Web Interface dialog window: Enter the WEP settings