User Manual
Table Of Contents
- Contents
- 1 Getting started
- 2 Installing the Access Point
- 3 Configuring the Access Point
- 3.1 Introduction
- 3.2 When to configure the Access Point
- 3.3 Starting the Web Interface
- 3.4 Launching Web Interface manually
- 3.5 Contents of Web Interface
- 3.5.1 Settings Summary
- 3.5.2 Wireless Settings
- 3.5.3 Security against unauthorized network access
- 3.5.4 To add a a client to the exception list
- 3.5.5 To delete a client from the exception list
- 3.5.6 Security against eavesdropping
- 3.5.7 Change WEP password
- 3.5.8 Security against unauthorized configuration
- 3.5.9 Identity
- 3.5.10 IP Settings
- 4 Troubleshooting
- 5 Technical specifications 11 Mbps WLAN Access Point
- 6 Regulatory notes and statements
- 6.1 Wireless LAN, Health and Authorization for use
- 6.2 Regulatory Information/disclaimers
- 6.3 USA-FCC (Federal Communications Commission) statement
- 6.4 FCC Radio Frequency Exposure statement
- 6.5 FCC Interference Statement
- 6.6 Export restrictions
- 6.7 Europe - EU R&TTE Declaration of Conformity
- 6.8 Restricted Wireless LAN device use in EU
- A TCP and IP settings
- B Wireless LAN
- Index
555004.doc
21
3 Configuring the Access
Point
3.1 Introduction
The Access Point is a ready to use device. It is delivered with default
settings which allow you to have access to it without configuring it.
When you do configure the Access Point, you can change the settings
with respect to security, radio channels, etc.
Whether you need to configure the Access Point or not, depends entirely
on how you apply the Access Point to your environment.
Section 3.2: ‘When to configure the Access Point’ on page 21 discusses
the consequences of configuring the Access Point or not.
Table 3-1 describes the contents of this chapter:
3.2 When to configure the Access Point
Configuring the Access Point means installing settings with respect to
the use of radio channels, security, identification, etc. You only need to
configure the Access Point when you want to change these settings.
Table 3-1 Overview of this chapter
Section Description
2 When to configure the Access Point
3 Starting the Web Interface for the first time.
4 Launching the Web Interface
5 Web Interface Settings