User Manual

Table Of Contents
555004.doc
17
Installing the Access Point Connecting the Access Point
You can find the power input and the UTP port on the left hand side of
the Access Point.
2.6.1 Power adapter
The Access Point package contains a power adapter. Attach it to the
Access Point. and then check the power LED (see section
2.7: ‘LEDs’ on page 18.) to see if you are connected properly.
2.6.2 UTP port
The UTP port can be found next to the power connector on the Access
Point.
For a wired connection (see section 1.4.2: ‘Extending a wired network
with one or more Access Points’ on page 10 and section
1.4.3: ‘Connecting an Access Point directly to a computer on page 11),
attach the UTP Ethernet cable to the Access Point and connect the
cable on the other end to either a hub in the network, or a computer.
If you want to connect to an Access Point via a wired connection, it must
be connected correctly:
if the Access Point is connected to a hub or switch, a ‘normal’ (not a
crosswired) cable must be used,
if the Access Point is connected directly to a computer, a crosswired
cable must be used.
Figure 2-4 Connecting the Access Point
Power
UTP port
R
eset