User Manual
Table Of Contents
- Contents
- 1 Getting started
- 2 Installing the Access Point
- 3 Configuring the Access Point
- 3.1 Introduction
- 3.2 When to configure the Access Point
- 3.3 Starting the Web Interface
- 3.4 Launching Web Interface manually
- 3.5 Contents of Web Interface
- 3.5.1 Settings Summary
- 3.5.2 Wireless Settings
- 3.5.3 Security against unauthorized network access
- 3.5.4 To add a a client to the exception list
- 3.5.5 To delete a client from the exception list
- 3.5.6 Security against eavesdropping
- 3.5.7 Change WEP password
- 3.5.8 Security against unauthorized configuration
- 3.5.9 Identity
- 3.5.10 IP Settings
- 4 Troubleshooting
- 5 Technical specifications 11 Mbps WLAN Access Point
- 6 Regulatory notes and statements
- 6.1 Wireless LAN, Health and Authorization for use
- 6.2 Regulatory Information/disclaimers
- 6.3 USA-FCC (Federal Communications Commission) statement
- 6.4 FCC Radio Frequency Exposure statement
- 6.5 FCC Interference Statement
- 6.6 Export restrictions
- 6.7 Europe - EU R&TTE Declaration of Conformity
- 6.8 Restricted Wireless LAN device use in EU
- A TCP and IP settings
- B Wireless LAN
- Index
555004.doc
13
Installing the Access Point Introduction
2 Installing the Access
Point
2.1 Introduction
This chapter describes the physical installation of an Access Point.
2.2 Access Point environment
When you install an Access Point, you must consider the following items:
• Connection to the electricity net.
• Connection to the network.
• Environment of device (heat/humidity): see chapter 5: ‘Technical
specifications 11 Mbps WLAN Access Point’ on page 41.
• Range of device: see chapter 5: ‘Technical specifications 11 Mbps
WLAN Access Point’ on page 41.
2.3 Physical installation of the Access Point
w
ww
w
The Access Point must be mounted in a vertical position always.
Table 2-1 Overview of this chapter.
Section Describes
2.2 Consideradions about the physical environment of
an Access Point.
2.3, 2.4, 2.5 How to install an Access Point.
2.6 How to connect the Access Point.
2.7 Explanation of the LEDs.
2.8 How to unlock/reset the Access Point.