Specifications

Conettix D6600/D6100i | Installation and Operation Guide | 4.0 D6600 Specific Cards
10 Bosch Security Systems, Inc. | 9/08 | 4998122704-04
4.1.1 D6640/D6641 LED Descriptions
The LED is active until the system acknowledges the
entire transmission and the telephone line is ready to
receive signals.
Figure 8: D6640/D6641 LED Descriptions
1
2
3
4
OL/LF
1
2
3
4
1 – Flashes green when an incoming call rings.
2 – Glows green when the receiver is online with
an incoming call.
3 – Glows red when the line card detects a line
fault condition.
4 – LED is off and ready to receive signals or is
disabled in the software.
4.1.2 Card Installation
Discharge static electricity from your
body by touching the receiver’s internal
frame (unpainted section) before
handling any circuit card.
Installing Terminator Cards
Refer to Figure 9 on page 11 when performing the
following steps:
1. Remove the two bracket screws that secure the
terminator card (or card slot cover, if this is a new
terminator card installation) to the back of the
D6600 chassis.
2. If you are removing an existing terminator card,
open the display door on the front of the D6600
and pull the line card slightly out, then re-insert.
This will push the existing terminator card out the
back of the D6600 chassis.
3. Remove the existing terminator card.
4. Insert the new terminator card in the same slot by
aligning the top and bottom of the terminator card
with the card guides in the D6600 chassis.
5. Slide the card into the D6600 chassis, wiggling
the card as you push until the card is flush with
the back of the chassis.
6. Secure the bracket screws at the top and bottom
of the terminator card. Ensure that the screws are
tight.
7. Repeat this process for all additional terminator
cards.
8. Connect appropriate telephone line cords to the
telephone line jack on the terminator cards.
9. Continue with Installing Line Cards on page 11.
Even if you are replacing an existing
terminator card, you must proceed to
Installing Line Cards on page 11.