Installation guide

D6600 | System Guide | 3.0 Operation
8 Bosch Security Systems, Inc. | 4/10 | 4998122712-04
11. The IP configuration for the PC is returned. The
following information is shown:
You must enter the correct subnet mask
and gateway for all devices that are on
this network. Contact the network
• Connection-specific DNS Suffix
administrator for these values.
• IP Address
8. If necessary, copy the requested files to the
computer. This might require Microsoft Windows
operating system disk for the version you are
using.
• Subnet Mask
• Default Gateway
9. After copying the files, you might need to restart
the PC. If so, connect the host PC’s NIC card to
the network (hub) and restart the PC.
10. After the PC restarts, perform the following check
to see if the previous procedures were entered
correctly.
Select Start Æ Programs Æ Accessories Æ
Command Prompt to open the Run dialog box.
A command prompt window appears.
Type ipconfig and press [ENTER].
Verify the IP address, subnet mask, and
all other listed information. This
information should match the IP and
subnet mask you assigned to this
computer in the previous steps.
If you have chosen to program the
D6600/D6100i’s initial network
parameters using the direct null modem
serial connection, continue with the
following steps. These steps are
necessary only if the host computer
running the D6200 Software is connected
to the D6600/D6100i’s COM4 port using a
direct NULL modem serial cable.
12. Select StartÆ SettingsÆ Control Panel to open
the Control Panel.
13. When the Control Panel window opens, double-
click the System icon.
14. The System Properties window opens.