Installation guide
Table Of Contents
- Contents
- Trademarks
- 1.0 Introduction
- 2.0 Overview
- 3.0 Operation
- 1.0
- 4.0 Special Conettix D6600 Applications
- Emulating a Direct Serial Connection Over a LAN Using D6680/D6682 Ethernet Network Adapters
- 1.0
- 1.0
- 5.0 D6100i Configuration Setup Instructions
- 6.0 Configuring for D6100i Network Communication
D6600 | System Guide | 3.0 Operation
.
Bosch Security Systems, Inc. | 4/10 | 4998122712-04 7
5. Scroll in the Components checked are used by
this connection: list and select Internet
Protocol (TCP/IP).
If the host computer is running Windows XP, 2000,
Vista, or Windows 7 and is new to the network, you
must perform the following steps:
Although the screen captures in this
procedure are specific to Windows 2000,
they are similar for Windows XP, Vista,
and Windows 7.
1. Select Start Æ Settings Æ Control Panel.
2. When the control panel is open, find and double-
click the Network and Dial-up Connections icon
to launch the Network and Dial-up Connections
control panel.
6. Select the protocol icon for TCP/IP and click
Properties.
3. Double-click Local Area Connection.
7. When the dialog box appears, select Use the
following IP address:.
Enter an IP address and subnet mask for the
network you are setting up.
4. Right-click the icon and select Properties.
If you have any questions about the
assignment of the IP address or subnet
mask, contact the network administrator.