Installation guide

D6600 | System Guide | 2.0 Overview
4 Bosch Security Systems, Inc. | 4/10 | 4998122712-04
Table 2: Network Adapters Part Numbers
Part Number Application Description
D6680-E120 Ethernet Network Adapter
ITS-D6682-UL
D6682 supplied with a
UL-approved transformer
(Group West/Part number -
48D-12-900).
ITS-D6682-INTL
D6682 supplied with a
international power supply with
regional adapters
All alarm panels (from Bosch or other manufacturers)
using the Conettix D6600/D6100i Network System
must have an interface (as described above) to allow
for network reporting. One method of interfacing an
alarm panel to a network is to use the C900V2 Dialer
Capture Ethernet Module.
For control panel manufacturers other
than Bosch, refer to the specific panel
installation guide for wiring, mounting,
and installation instructions.
The C900V2 and C900TTL-E modules (refer to
Figure 3, page 5) operate with almost any alarm panel
(Bosch or other manufacturer) that uses a standard
digital dialer with one of the following industry
standard formats:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
All Radionics Modem formats
DTMF
DTMF (where dialer retransmits quickly)
BFSK (2300 Hz ACK & 1400 Hz ACK Tone)
FBI Superfast DTMF (2300 Hz & 1400 Hz ACK
Tone)
Pulse 3/1, 3/1 Checksum (2300 Hz & 1400 Hz
ACK Tone)
Pulse 4/2 (Long 2300 Hz & Long 1400 Hz ACK
Tone)
SIA Bell 103 (110/300 baud, 2016 Hz ACK Tone)
ADT-SIA
Telim
Robofon
SIA Bell 103 (110/300 baud, 2083 Hz ACK Tone)
SIA V.21 (110/300 baud)
Seriee DTMF
Seriee FSK
The C900V2 and C900TTL-E operate with these
formats by using dial tone and handshake
simulations. The C900V2 and C900TTL-E intercept
the alarm panel’s signals and transmit them across
the network to a network-enabled D6600/D6100i.
For UL Fire Listed applications, refer to
the C900V2 UL Listed FACPs
Compatibility List (P/N: F01U010036) or
the C900TTL-E Compatibility List
(P/N: 4998141056).
For control panel manufacturers other
than Bosch, refer to the specific panel
installation guide for wiring, mounting and
installation instructions.