Installation guide
Table Of Contents
- Contents
- Trademarks
- 1.0 Introduction
- 2.0 Overview
- 3.0 Operation
- 1.0
- 4.0 Special Conettix D6600 Applications
- Emulating a Direct Serial Connection Over a LAN Using D6680/D6682 Ethernet Network Adapters
- 1.0
- 1.0
- 5.0 D6100i Configuration Setup Instructions
- 6.0 Configuring for D6100i Network Communication
D6600 | System Guide | 5.0 D6100i Configuration Setup Instructions
18 Bosch Security Systems, Inc. | 4/10 | 4998122712-04
8. At the I/F Mode prompt, press [ENTER] to accept
the default (4C).
20. At the Disable Port 77FEh prompt, press
[ENTER] to accept the default (N).
9. At the Flow prompt, press [ENTER] to accept the
default (00).
Disabling the telnet and port 77FE
prevents you from accessing the set-up
10. Type a unique Port Number for the LAN to which
the D6100i is connected and press [ENTER].
menu for future changes.
11. At the ConnectMode prompt, press [ENTER] to
accept the default (CC).
21. At the Disable Web Server prompt, press
[ENTER] to accept the default (N).
12. At the Datagram Type prompt, type 00 or 02 and
press [ENTER].
22. At the Disable ECHO ports prompt, press
[ENTER] to accept the default (Y).
13. At the IP addr prompt, type the remote IP
address used for the D6600 to which the C900V2
reports and press [ENTER].
23. At the Enable Encryption prompt, type y and
press [ENTER].
24. At the Change keys prompt, type y and press
[ENTER].
Enter the remote IP address using
000.000.000.000 format.
25. Type the key and press [ENTER].
15. Type the Port Number for the D6600 and press
[ENTER].
The key is 16 bytes (32 characters) long. Enter
the key using the 01-02-03-04-05-06-07-08-09-
10-11-12-13-14-15-16 format.
If you want to enable encryption, continue with the
next step. If not, go to step
27.
26. At the Enable Enhanced Password prompt,
press [ENTER] to accept the default (N).
If encryption is enabled on the
D6100i, it must be enabled on all field
devices..
27. Type 9 and press [ENTER] to save changes and
exit from the telnet session.
16. From the Change Setup menu, type 6 and press
[ENTER].
To confirm that the IP address is configured properly,
use the ping utility:
28. At the C:\> prompt, type ping <IP Address> and
press [ENTER].
This information appears.
Four reply messages are received, confirming the
D6100i is communicating on the network.
Configuration of the D6100i is complete.
17. At the Disable SNMP prompt, press [ENTER] to
accept the default (N).
18. At the SNMP Community Name prompt, press
[ENTER] to accept the default (blank).
19. At the Disable Telnet Setup prompt, press
[ENTER] to accept the default (N).