Installation guide

D6600 | System Guide | 5.0 D6100i Configuration Setup Instructions
.
Bosch Security Systems, Inc. | 4/10 | 4998122712-04 17
5.4.1 Configuration Using Telnet
The following prompt appears:
1. Type 0 (zero) and press [ENTER] to set up the
basic server configuration.
5. Press [ENTER] to accept the password setting at
none.
If the D6100i was previously programmed with an
IP address, the address appears in parentheses.
In most cases, do not assign a
2. Type the IP address (for example,
190.200.128.219) and press [ENTER].
password. If a password is necessary,
store it in a safe place. If you lose or
3. If the Gateway address is required, type y, press
[ENTER] and then type the address and press
[ENTER].
forget the password, you cannot
connect to D6100i using telnet until you
send the unit to the factory for password
removal, and the unit is returned to you.
If the Gateway address is not required or if you
use DHCP, type n and press [ENTER]
The Setup Mode information appears.
The following prompt appears.
The Gateway IP is required only if you
are connecting to a WAN. In a LAN,
the Gateway IP is usually not needed
unless the Gateway IP of the PC is
different from the Gateway to which
the D6100i is connected.
4. If Network needs to be changed from the default,
enter the number of bits that correspond to the
netmask your network uses and press [ENTER].
Refer to
Table 4.
Contact your network administrator if you need
more information about the netmask.
Table 4: Netmask Address
6. Type 1 and press [ENTER] to set up Channel 1
configuration.
This information appears.
Netmask Netmask
Host
Bits
Host
Bits
1 255.255.255.254 17 255.254.0.0
2 255.255.255.252 18 255.252.0.0
3 255.255.255.248 18 255.248.0.0
4 255.255.255.240 20 255.240.0.0
5 255.255.255.224 21 255.224.0.0
6 255.255.255.192 22 255.192.0.0
7 255.255.255.128 23 255.128.0.0
8 255.255.255.0 24 255.0.0.0
9 255.255.254.0 25 254.0.0.0
10 255.255.252.0 26 252.0.0.0
11 255.255.248.0 27 248.0.0.0
12 255.255.240.0 28 240.0.0.0
13 255.255.224.0 29 224.0.0.0
14 255.255.192.0 30 192.0.0.0
15 255.255.128.0 31 128.0.0.0
16 255.255.0.0
If the default value displayed in your
Telnet window does not match the
value listed in any of the steps below,
type the correct value and press
[ENTER].
7. At the Baud Rate prompt, press [ENTER] to
accept the default (38400).