Manualshelf

Owner`s manual

ManualsBrandsConergy ManualsHome building and DecorActive System
78910111213141516
ENGLISH
Conergy AS
Owners Manual
13
| All gas work must comply with local regulations including AS5701/AG601 and AS/NZ 3500.4.
| All gas work must be conducted by a suitability licensed gas fitter.
| Installation of the gas heater must be carried out in accordance with the installation instructions
supplied with the gas heater.
| Conergy systems only use approved gas heaters.
| Particular attention must be given to the gas supply system in order to ensure the there is a
sufficient gas supply available to the gas heater when operating at full output burner rate.
Approved gas heater models
Gas heater models used with Conergy solar water heater systems must be certified to all local
requirements, be automatic ignition and have full flame modulation. Gas heaters other than this type
must not be used with a Conergy solar water heater. Particularly fixed pilot and fixed flame models
must not be used under any circumstances.
Commissioning
When all connections have been completed the split system can be filled with water.
1. Before turning on the cold water supply open one hot tap within the household to release air
from the system during the filling process. Do not leave the open tap unattended during the
filling process.
2. Turn on the cold water supply and wait for the system to fill. When water flows without air bursts
from the open hot tap it can be closed which will pressurise the solar water heater system.
3. Once the system is pressurised all connections on the water heater must be checked for leaks
and repaired if necessary.
4. When the system is proven water tight, power and gas can be applied to the AES system.
To test that the element is operational, turn the circuit breaker in the switch board on and off, you
should see the power meter’s speed change during this action if a disc type meter is installed.
For gas AES systems turn on a hot water tap and the gas heater will ignite provided the water
temperature is less than 60 °C.
The solar water heater is now fully operational. Enjoy your Conergy Split System.
5 Gas (AES) Installation Instructions
5 Gas (AES) Installation Instructions