Installation manual

ManualsBrandsConergy ManualsHome building and DecorActive System

ENGLISH

Conergy AS

Owners Manual

6.3.3 Final connections:

1. Fit the 600mm Flexible Connector (P/No 60-

1124) to the top Fill Fitting on the Pump Module.

This connector is used for the Solar Flow line,

and is designed to be long enough to reach a

stub-out or similar connection on the wall.

2. Fit a 225mm Flexible Connector (P/No 60-1115)

to the other brass nipple on the HEM-25-B

module. This connector is used for the Solar

Return line, and is designed to be long enough

to reach a stub-out or similar connection on the

wall.

3. Plug the Hot Temperature Probe Assembly (P/No 35-1007) into the socket on the base of the Pump

Module. This plug will only ﬁt one way. The temperature probe is inserted into the thermowell at

the hot connection of the collectors.

4. Ensure that the probe pocket is dry before inserting the probe and that it is sealed with silicone

or another suitable weather protection once the probe is in place.

6.3.2 Installing the pump module:

1. Ensure that the pump module is installed in an accessible position.

2. Fit the brass nipples (P/No 60-5066) to both the connection ports on the HEM-25-B module.

3. Take one Fill Fitting (P/No 60-5157), and using a suitable thread sealant, fasten to the outlet side

of the pump on the pump module. Remove the

check valve in this port on PM-600 modules.

4. Take the second Fill Fitting and fasten it to the

Gland Union (P/No 60-1032) using a suitable

thread sealant. Attach the Gland Union to the

Pump Module. A seal is obtained at this

junction by the rubber washer of the Gland

Union.

5. Loosely attach one end of the 225mm Flexible

Connector (P/No 60-1115) to the brass nipple

on the HEM-25-B module. Loosely attach the

other end to the bottom ﬁll ﬁtting on the pump

module.

5. With the ﬂexible connector loosely ﬁtted, move the pump module into position on the storage vessel

and ﬁx in place with the self-drilling screws supplied. Ensure the ﬂexible connector is not kinked in

any way, and the pump module is vertical. Tighten the loose nuts on the ﬂexible connector.

60-5157

60-1032

60-5157

60-1115

60-5066

6 Connections at the Storage Tank

60-1115

35-1007

60-1117