Installation manual

ENGLISH

Conergy AS

Owners Manual

The Storage Tank is installed and connected to the plumbing installation as normal and detailed

in the Conergy installation instructions supplied with the water heater. The household plumbing

connections should be made to the tank socket ﬁttings on the left side of the storage tank. This

leaves the right side ﬁttings free for connection to the solar collector system.

Note: Installation of solar water heaters in Australia requires a tempering valve on the hot water

supply from the unit for correct installation and safe temperature regulation.

Removing the hot scoop from the storage tank

Using the Wire Hook device supplied (P/No 60-3020), remove the hot scoop from the outlet ﬁtting

of the storage tank. This will not be required for all tanks. Please check the scoop orientation and

ensure it is pointing down. If it points up, please follow this procedure:

15-1012

6 Connections at the Storage Tank

6.1

Insert the hook end of the Wire Hook into the

outlet socket.

NB: - Have the open side of the hook facing down

on insertion.

Put the Wire Hook into the socket until the tee

section reaches the water heater case and can

go no further.

Gently pull back on the hook wire until you feel

the hook take hold of the hot scoop. Once the

hook has taken hold, pull back on the wire hook.

The hot scoop will be withdrawn from the water

heater. During the withdrawal process you will

notice that the scoop was facing upward, toward

the top of the water heater.

Once the hot scoop is withdrawn, discard it.

For Closed Circuit Systems, this procedure is now complete. Proceed to section 9.4. For Open

Circuit Systems, continue to the following step.

5. Reinsert the longer scoop (P/No 15-1012) into the outlet socket making sure that it is pointing

down. It may require some force.

Existing Hot

Scoop

60-3020

Wire Hook

engaged

Pull out

existing Hot

Scoop