Installation manual

6 Installation Instructions
Envirosun TS Installation Manual Rev5b PVNW.docx Page 19
13. Using the self-drilling screws supplied, screw fix
the collector rail to the collectors as shown in
Figure 6.3. Use two (2) per collector.
14. Finally, using two (2) of the self-drilling screws
supplied, screw fix the collector straps to the
collector rail and collector/s. The collector/s are
now mounted.
15. Continuing, slide a Compression Plug assembly
(Figure 6.4) to the top left and bottom right
corners of the collector array. Tighten the
assembly taking care not to twist the copper
tubes of the collector.
16. Place the tank centrally above the collector array,
at the position identified in point 1 above. Move
the tank so it is touching the top of the collector
array.
17. Using the straps supplied with the Parts Kit, place
one into each end of the tank, hooking onto the
front foot. Slide them along the tank so they are
positioned above the rafters/trusses.
18. Take the tank clamp and bolt it to the tank strap
behind the tank. To complete the security, screw
fix the 2 tank clamps to the tank using the two (2)
self-drilling screws provided (Figure 6.5).
19. Now, screw-fix the tank straps to the rafters. The
tank is now mounted.
20. Continuing, it is time to fit the flexible hot
connection pipe. This procedure will differ
between models, so refer to the appropriate
picture.
21. Slide the appropriate compression union/elbow
onto the tank and collector pipes. Tighten the
assemblies taking care not to twist the copper
tubes. Insert one end of the flexible connection
pipe to a union/elbow, and gently bend the pipe
and insert to the other union. Tighten the
assemblies onto the flexible connection pipe
taking care not to twist the pipe.
Figure 6.3 Collector Mounting
Figure 6.4 Compression Plug
Figure 6.5 Tank Clamp
Figure 6.8 Hot Pipe - Closed Circuit
Figure 6.7 Hot Pipe - TS300 Open
Circuit
Figure 6.6 Hot Pipe - TS180 Open
Circuit