Installation manual
ENGLISH
Conergy TS
Installation Manual
3
1 Installation Information
Storage Tank & Solar Collectors
The potable water storage tank is used to store the heated water ready for household use. It is
constructed using high quality vitreous enamel lined low carbon steel to provide long life. The
tank is insulated with a high density polyurethane material to ensure minimal heat losses and
maximmum structural strength.
The solar collectors contain a multi tube copper water way system bonded to a solar absorber
plate, the combination of which collects solar energy and transfers it to the fluid within the collector
circuit. The absorber plate system is enclosed in an insulated metal casing covered with a high
strength toughened glass sheet that protects the absorber system from physical damage.
Ancillary Energy Support (AES) - Booster System
Electricity and gas are the two options for the AES system. Please assist the customer in choosing
the most suitable AES system type. An electric Ancillary Energy Support (AES) system uses an
electric element to heat part of the stored household water on those occasions when there is
reduced solar energy available e.g. cloudy days.
The electricity supply to the electric element within the storage tank is automatically controlled
by an internal thermostat which will only allow the electric element to operate if the storage tank
water temperature falls below 60 °C and will, even then, only consume electricity until the water
temperature is increased to 60 °C at which stage it turns off automatically.
1.3.1
1.3.2
Conergy TS 300 litre vitreous enamel tank
LC collector