User`s guide

EXPANSION PORT MOUNTING
10
2.6. SIM Card Reader
The SIM card reader for 3 V and 1.8 V SIM cards is located on the front panel
of the router. To initiate the router into operation it is necessary to insert an activated SIM card
with unblocked PIN in the reader. The SIM cards might be of different adjusted APN (Access
Point Name).
2.7. Power Supply
The router requires +10 V DC to +30 V DC supply. Protection against reversed polarity
without signaling is built into the router.
The power consumption during receiving is 1W. The peak power consumption during
data sending is 3.5W. For correct operation it is necessary that the power source is
able to supply a peak current of 500mA.
2.8. Technical parameters
UR5 v2
Complies with standards EN 301 511, v9.0.2,
EN 301 908-1&2, v3.2.1,
ETSI EN 301 489-1 V1.8.1,
EN 60950-1:06 ed.2 +A11:09
HSDPA parameters 3GPP rel. 5 standard
bitrate 3.6 Mbps/384 kbps
UE CAT. 1 to 6, 11, 12
Data compress 3GPP TS25.212
UMTS parameters W-CDMA FDD standard
PS bitrate – 384/384 kbps
CS bitrate – 64/64 kbps
GPRS parameters GPRS multislot class 10, CS 1 to 4
EGPRS multislot class 10, CS 1 to 4,
MCS 1 to 9
Transmit power Class 3 (+23dBm) for UMTS 900/2100MHz
Temperature range Function
Storage
-30
o
C to +60
o
C
-40
o
C to +85
o
C
Protection Freely
In switch board
IP20
IP56
Supply voltage 10 to 30 V DC
Consumption Reception
GPRS
UMTS/HSDPA
300 mW
to 3,5 W (GPRS transmission)
to 5,5 W (UMTS/HSDPA transmission)
Dimensions 42x76x113 mm (DIN 35mm)
Weight UR5 v2 – 150 g
UR5 v2 SL – 280 g
Antenna connector SMA– 50 Ohm
User interface ETH
USB
PORT1
PORT2
Ethernet (10/100 Mbit/s)
USB 2.0 type A host
Optional RS232/RS485/ETHERNET/M-BUSD
or inputs/outputs (I/O)
Optional RS232/RS485/M-BUSD