System information

1. CONFIGURATION OVER WEB BROWSER
1.27 USB port configuration
The USB port configuration can be called up by airbrush option USB Port in menu. Con-
figuration can be done, if we have USB/RS232 converter.
Item Description
Baudrate Applied communication speed.
Data Bits Number of data bits.
Parity Control parity bit
• none – Will be sent without parity.
• even – Will be sent with even parity.
• odd – Will be sent with odd parity.
Stop Bits Number of stop bit.
Split Timeout Time to rupture reports. If you receive will identify the gap between
two characters, which is longer than the parameter value in millisec-
onds. Then all of the received data compiled and sent the message.
Protocol Communication protocol:
• TCP – communication using a linked protocol TCP
• UDP – communication using a unlinked protocol UDP
Mode Mode of connection:
• TCP server – The router will listen to incoming requests about TCP
connection.
• TCP client – The router will connect to a TCP ser ver on the specified
IP address and TCP port.
Server Address In mode TCP client it is necessary to enter the Server address and
final TCP port.
TCP Port In both modes of connection is necessary to specify the TCP port on
which the router will communicate TCP connections.
Table 63: USB port configuration 1
After check Check TCP connection, it activates verification of established TCP connection.
Item Description
Keepalive Time Time, after which it will carry out verification of the connection
Keepalive Interval Waiting time on answer
Keepalive Probes Number of tests
Table 64: USB PORT configuration 2
69
LUCOM GmbH * Ansbacher Str. 2a * 90513 Zirndorf * Tel. [phone] * Fax. [phone] * www.lucom.de