System information

1. CONFIGURATION OVER WEB BROWSER
Continued from previous page
Item Description
• TCP client – OpenVPN will communicate using TCP in client
mode.
UDP/TCP port Port, by which the tunnel will communicate.
Remote IP Address IP address of the opposite side of the tunnel. Can be used do-
main name.
Remote Subnet Network IP address of the opposite side of the tunnel.
Remote Subnet Mask Subnet mask of the opposite side of the tunnel.
Redirect Gateway By this parameter is possible to redirect all traffic on Ethernet.
Local Interface IP
Address
IP address of the local side of tunnel.
Remote Interface
IP Address
IP address of interface local side of tunnel.
Ping Interval This parameter defines the time period after which router sends
a message to opposite side of tunnel, for check the existence of
the tunnel.
Ping Timeout Ping Timeout waits on message from off-side tunnel. For Open-
VPN tunnel right verifies parameter Ping Timeout has to be big-
ger than Ping Interval.
Renegotiate Interval Sets renegotiate period (reauthorization) of the OpenVPN tunnel.
This parameter is possible to set only at username/password au-
thentication or at X.509 certificate using. After this time period,
the router changes the encryption tunnel to ensure the continued
safety of the tunnel.
Max Fragment Size By parameter Max Fragment Size it is possible to define maxi-
mum sending packet size.
Compression Sending data is possible compress
• none – No compression is used.
• LZO – Are used lossless LZO compressions. Compression has
to be on both tunnel ends.
NAT Rules By parameter NAT Rules it is possible to apply set NAT rules
to OpenVPN tunnel.
• not applied – NAT rules to OpenVPN is not applied.
• applied – NAT rules to OpenVPN is applied.
Authenticate Mode This parameter can be set authentication mode.
• none – is used any authentication mode
Continued on next page
35
LUCOM GmbH * Ansbacher Str. 2a * 90513 Zirndorf * Tel. [phone] * Fax. [phone] * www.lucom.de