System information

1. CONFIGURATION OVER WEB BROWSER
1.13 PPPoE Configuration
The PPPoE Configuration item is available only for the industrial router XR5i v2.
PPPoE for industrial router works in client mode. Router using connection to the PPPoE
server or PPPoE bridge (for example ADSL modem).
To enter the PPPoE configuration select the PPPoE menu item. If the Create PPPoE con-
nection option is selected, the router tries to establish PPPoE connection after switching-on.
PPPoE (Point-to-Point over Ethernet) is a network protocol, which PPP frames encapsulat-
ing to the Ethernet frames. PPPoE client to connect devices that support PPPoE bridge or
a server (typically ADSL router). After connecting the router obtains the IP address of the
device to which it is connected. All communications from the device behind the PPPoE server
is forwarded to industrial router.
Item Description
Username Username for secure access to PPPoE
Password Password for secure access to PPPoE
Authentication Authentication protocol in GSM network
• PAP or CHAP – Router is chosen one of the authentication methods.
• PAP – It is used PAP authentication method.
• CHAP – It is used CHAP authentication method.
MRU (Maximum Receiving Unit) – it is the identifier of the maximum size
of packet, which is possible to recese in given environment. Default
value is set to 1492 bytes. Other settings may cause incorrect data
transmission.
MTU (Maximum Transmission Unit) – it is the identifier of the maximum size
of packet, which is possible to transfer in given environment. Default
value is set to 1492 bytes. Other settings may cause incorrect data
transmission.
Table 24: PPPoE configuration
Figure 23: PPPoE configuration
27
LUCOM GmbH * Ansbacher Str. 2a * 90513 Zirndorf * Tel. [phone] * Fax. [phone] * www.lucom.de