System information

1. CONFIGURATION OVER WEB BROWSER
By each of the interfaces is then shown the following information:
Item Description
HWaddr Hardware (unique) address of networks interface
inet IP address of interface
P-t-P IP address second ends connection
Bcast Broadcast address
Mask Mask of network
MTU Maximum packet size that the equipment is able to transmit
Metric Number of routers, over which packet must go trought
RX • packets – received packets
• errors – number of errors
• dropped – dropped packets
• overruns – incoming packets lost because of overload
• frame – wrong incoming packets because of incorrect packet size
TX • packets – transmit packets
• errors – number of errors
• dropped – dropped packets
• overruns – outgoing packets lost because of overload
• carrier – wrong outgoing packets with errors resulting from the physi-
cal layer
collisions Number of collisions on physical layer
txqueuelen Length of front network device
RX bytes Total number of received bytes
TX bytes Total number of transmitted bytes
Table 9: Description of information in network status
It is possible to read status of connection to mobile network from the network information.
If the connection to mobile network is active, then it is in the system information shown as a
ppp0 interface.
For industrial router XR5i v2, interface ppp0 indicates PPPoE connection.
7
LUCOM GmbH * Ansbacher Str. 2a * 90513 Zirndorf * Tel. [phone] * Fax. [phone] * www.lucom.de