System information

CONFIGURATION

Control SMS message doesn’t change the router configuration. If the router is

switched to offline mode by the SMS message the router will be in this mode up to next

restart. This behavior is the same for all control SMS messages.

It is possible to send controls SMS in the form:

$$ "!+

go online sim 1 Switch to SIM1 card

go online sim 2 Switch to SIM2 card

go online Switch router in online mode

go offline PPP connection termination

set out0=0 Set output I/O connector on 0

set out0=1 Set output I/O connector on 1

set out1=0 Set output expansion port XC-CNT on 0

set out1=1 Set output expansion port XC-CNT on 1

set profile std Set standard profile

set profile alt1 Set alternative profile 1

set profile alt2 Set alternative profile 2

set profile alt3 Set alternative profile 3

reboot Router reboot

get ip Router send answer with IP address SIM card

Table 48: Control SMS

By choosing Enable AT-SMS protocol on expansion port 1 and Baudrate it is

possible to send/receive an SMS on the serial Port 1.

 "!+

Baudrate Communication speed expansion port 1

Table 49: Send SMS on serial PORT1 configuration

By choosing Enable AT-SMS protocol on expansion port 2 and Baudrate it is

possible to send/receive an SMS on the serial Port 2.

 "!+

Baudrate Communication speed expansion port 1

Table 50: Send SMS on serial PORT1 configuration

By choosing Enable AT-SMS protocol on TCP port and enter the TCP port it is

possible to send/receive an SMS on the TCP port. SMS messages are sent by the help

of a standard AT commands.

 "!+

TCP Port TCP port on which will be allowed to send/receive SMS messages.

Table 51: Send SMS on ethernet PORT1 configuration

'(2('($$$

After establishing connection with the router via serial interface or Ethernet, it is

possible to use AT commands for work with SMS messages.

The following table only lists the commands that are supported by Conel's routers.

For other AT commands is always sent OK response. There is no support for treatment of

complex AT commands, so in such a case router sends ERROR response.