System information

CONFIGURATION
'('&(4($!-$!!)
At the bottom of configuration it is possible to set rules for switching between three
SIM cards (or between APNs). The third SIM card is used for CDMA and remaining SIM
cards are standard for UMTS (for more information about both technologies in conjuction
with this router can be found in the user's guide).
 "!+
Default SIM card This parameter sets default APN or SIM card, from which it will try
to establish the PPP connection. If this parameter is set to none, the
router launches in off-line mode and it is necessary to establish PPP
connection via SMS message.
Table 17: Default SIM card configuration
 "!+
Switch to other SIM card when
connection fails
If PPP connection fails, then this parameter ensures switch
to backup SIM card or APN of the SIM card. Failure of the
PPP connection can occur in two ways. When I start the
router, when three fails to establish a PPP connection. Or if it
is checked Check the PPP connection, and is indicated by
the loss of a PPP connection.
Switch to _____ when roaming
is detected and switch to default
SIM card when home network
is detected
In case that the roaming is detected this parameter enables
switching to selected SIM card or APN of the SIM card. If the
home network is detected, this parameter enables switching
back to default SIM card.
Switch to _____ when data limit
is exceeded and switch to
default SIM card when data limit
isn't exceeded
This parameter enables switching to selected SIM card or
APN of the SIM card, when the data limit of default APN is
exceeded. This parameter also enables switching back to
default SIM card, when data limit is not exceeded.
Switch to _____ when binary
input is active switch to default
SIM card when binary input isn't
active
This parameter enables switching to selected SIM card or
APN of the SIM card, when binary input ‘bin0’ is active. If
binary input isn't active, this parameter enables switching
back to default SIM card.
Switch to _____ when signal
level drops below _____ -dBm
(and is above _____ -dBm on
target configuration) and switch
to default SIM card when signal
level is above _____ -dBm
This parameter enables switching to selected SIM card or
APN of the SIM card, when the signal level drops below
selected value (and is above selected value on target
configuration). If the signal level is above selected value, this
parameter enables switching back to default SIM card.
Switch to primary SIM card after
timeout
This parameter defines the method, how the router will try to
switch back to default SIM card or default APN.
Table 18: Switch between SIM card configurations
18