System information

ManualsBrandsConel ManualsComputer equipmentUCR11 v2

1. CONFIGURATION OVER WEB BROWSER

1.13.5 Switch between SIM cards conﬁguration

At the bottom of conﬁguration it is possible to set rules for switching between three SIM

cards (or between APNs). The third SIM card is used for CDMA (if the router is equipped with

WIFI) and the remaining SIM cards are standardly designed for LTE/HSPA+ (more information

about used technologies can be found in the user’s guide).

Item Description

Priority This parameter sets default SIM card, from which it will try to es-

tablish the connection to mobile network. If this parameter is set

to not set, the router launches in ofﬂine mode and it is necessary

to establish connection to mobile network via SMS message.

Table 22: Default SIM card conﬁguration

Item Description

Switch to other SIM card when

connection fails

If connection to mobile network fails, then this param-

eter ensures switch to secondary SIM card or sec-

ondary APN of the SIM card. Failure of the connection

to mobile network can occur in two ways. When I start

the router, when three fails to establish a connection

to mobile network. Or if it is checked Check the con-

nection to mobile network, and is indicated by the loss

of a connection to mobile network.

Switch to _____ when roaming

is detected and switch to default

SIM card when home network is

detected

In case that the roaming is detected this parameter en-

ables switching to speciﬁed SIM card or APN. If home

network is detected, this parameter enables switching

back to default SIM card. For proper operation, it is

necessar y to have enabled roaming on your SIM

card!

Switch to _____ when data limit

is exceeded and switch to de-

fault SIM card when data limit

isn’t exceeded

This parameter enables switching to speciﬁed SIM

card or APN, when the data limit of default APN is ex-

ceeded. This parameter also enables switching back

to default SIM card, when data limit is not exceeded.

Switch to _____ when binary in-

put is active switch to default

SIM card when binary input isn’t

active

This parameter enables switching to speciﬁed SIM

card or APN, when binary input ’bin0’ is active. If bi-

nary input isn’t active, this parameter enables switch-

ing back to default SIM card.

Continued on next page