User`s guide

EXPANSION PORT MOUNTING
9
2.4. SIM Card Reader
The SIM card reader for 3 V and 1.8 V SIM cards is located on the front panel
of the router. To initiate the router into operation it is necessary to insert an activated SIM card
with unblocked PIN in the reader. The SIM cards might be of different adjusted APN (Access
Point Name).
2.5. Power Supply
The router requires +10 V DC to +30 V DC supply. Protection against reversed polarity
without signaling is built into the router.
The power consumption during receiving is 1W. The peak power consumption during
data sending is 5.5W. For correct operation it is necessary that the power source is able
to supply a peak current of 500mA.
2.6. Technical parameters
ER75i v2
Complies with standards EN 301 511, V9.0.2
EN ETSI 301 489-1 V1.9.1
EN 60950-1:06 ed.2 + A11:09
Frequency bands EGSM850, EGSM900, GSM1800
and GSM1900
Transmit power Class 4 (2 W) for EGSM850
Class 4 (2 W) for EGSM900
Class 1 (1 W) for GSM1800
Class 1 (1 W) for GSM1900
Temperature range Operation
Storage
-30
o
C to +60
o
C
-40
o
C to +85
o
C
Protection rating Freely
In switch board
IP20
IP56
Supply voltage +10 až +30 V DC
Consumption Reception
Transmission
1 W
5,5 W
Dimensions 42x76x113 mm (DIN 35mm)
Weight ER75i v2 – 150 g
ER75i v2 SL – 280 g
Antenna connector SMA – 50 Ohm
User interface ETH
USB
PORT1
PORT2
Ethernet (10/100 Mbit/s)
USB 2.0 type A host
Optional RS232/RS485/ETHERNET/M-BUSD
or inputs/outputs (I/O)
Optional RS232/RS485/M-BUSD
LUCOM GmbH * Ansbacher Str. 2a * 90513 Zirndorf * Tel. [phone] * Fax. [phone] * www.lucom.de