User Manual

9
Prepare Conduit for Cable
1. Remove Conduit Pulling Eye from receiving end of Conduit.
2. Open Handheld Blower (See Figure 12)
3. Pour recommended (silicon-
b
ased) lubricant into Conduit opening before
Foam Carrier ¼ of the total recommend amount (See Figure 13) foam
carriers are not provided with the Handheld blower. (See Page 19 for
recommend amount of lubrication).
4. Insert foam into conduit (See Figure 14).
5. Insert Seal Disk in venturi slot if not already in place. (Figure 15).
Figure 12 Open handheld blower
Figure 1 3 Add
lubricant
Figure 1 4 Ins ert foam carrier
Figure 15 Insert seal disk