Manual

Set Up the Blower

This manual contains setup and operating instructions for the Gulfstream 200 micro

fiber blower.

A. DETERMINE FIBER SIZE

Determine size of fiber to be installed. To provide optimal traction and grip, if fiber

diameter is 1.5mm or less, the top belt of blower must be changed to a flat belt which

is included in the common parts kit. This flat belt is to be used in combination with the

bottom grooved belt, so that adequate contact and proper push force can be applied

to the fiber. Refer to Section 9 for belt replacement instructions.

B. SELECT CABLE SEAL & DUCT PACK

Choose the correct cable seal and duct pack for the particular application according to

duct and cable size. Refer to Cable Seal and Duct Pack selection charts.

CABLE SEAL SELECTION

CABLE OD (mm) CABLE SEAL KIT PN DUCT PACK PN

0.8-1.5 08783074 08783051; 08783052; 08783053

1.5-2.0 08783057 08783051; 08783052; 08783053

2.0-2.5 08783058 08783051; 08783052; 08783053

2.5-3.0 08783064 08783051; 08783052; 08783053

3.0-3.5 08783059 08783051; 08783052; 08783053

3.5-4.0 08783060 08783052; 08783053

4.0-4.5 08783061 08783052; 08783053

4.5-5.0 08783062 08783052; 08783053

5.0-5.5 08783063 08783052; 08783053

DUCT PACK SELECTION

DUCT OD (mm) DUCT PACK PN

5.0mm 08783051

7.0mm 08783051

8.0mm 08783052

8.5mm 08783052

10.0mm 08783052

12.0mm 08783053

12.7mm 08783053