USER'S GUIDE & SAFETY MANUAL USER'S GUIDE & SAFETY MANUAL Extension Frame
Important Safety Notice Read and understand all procedure and safety instructions before using the Condux CableGlider Cable Puller Extension Frame. Observe all safety information on these pages and note specific safety requirements as explained by procedures called out in this manual. Failure to follow these instructions could result in serious personal injury or death. ADvERTENCIA: Favor de leer y comprender todas las instrucciones de operación y seguridad antes de usar la máquina. Si Ud.
General Information The Condux CableGlider Cable Puller Extension Frame is designed for pulling jobs were a longer reach and added stability are necessary. It is ideal for pulling from deep manholes (Figure 1) or high overhead ducts (Figure 2). Extra slack can be pulled with the Extension Frame when needed for termination. The extension frame is designed for use with the Condux CableGlider Cable Puller and its accessories. 2" Sch 40 GRC steel duct for the Extension Frame is not included. Figure 1 1.
3. Components Two Extension Frame Kits available- One for Plus and HD CableGlider Cable Pullers (Figure 3) and One for the STD CableGlider Cable Puller (Figure 4).
Assembly Instructions A. PREPARE CONDUIT FOR DUCT END JOINT Corresponding size Conduit Adapter fits into Retaining Fork and is secured by tightening thumb screws. Conduit Adapter is then inserted into conduit (Figure 5). (Conduit Adapters and Retaining Fork for 2", 3", 3 1/2" and 4" conduit are included with CableGlider Cable Puller. Larger sizes are available from Condux.) B. ATTACH DUCT END JOINT TO RETAINING FORK 4.
Figure 8 Figure 9 D. ATTACH CABLE PULLER ADAPTER TO CABLE PULLER The HD and Plus (Figure 8), & STD Extension Frame Cable Puller Adapters (Figure 9) attach to the corresponding CableGlider Cable Puller pivot arm on milled slots. The Cable Puller Adapter can be adjusted and is secured with locking pins. IMPORTANT: The adapter will only attach to the first pivot arm.
Figure 12 Figure 13 F. CONNECT USING CENTER JOINT If applicable, the Center Joint can be adjusted to match Extension Frame configuration and is secured with locking pins. The 2" Sch 40 GRC steel duct from the Duct End Joint and from Cable Puller Adapter connects to the Extension Frame Center Joint in the cylindrical duct ports and is locked in place by tightening the cap screws and lock nuts (Figure 11).
Warranty Information 5. Condux International, Inc.