Owner's manual
A. PREPARING THE CABLE - THE CENTERING TOOL
First, it is recommended that you square off the end of the cable. This ensures that the pulling
eye will go on as far as possible.
From the chart below, locate the proper centering tool. Place the centering tool on the end of the
cable as close to the center as possible. Drive the centering tool into the cable up to the head of
the centering tool. This will push some of the grease from the cable and separate the wire pairs,
making way for the spike inside of the pulling eye.
Cable O.D.
Up To (in.)
Cable O.D.
Up To (mm)
Centering Tool
Part Number
Cable O.D.
Up To (in.)
Cable O.D.
Up To (mm)
Centering Tool
Part Number
1.0552708945011 2.402 6108945027
1.1522908945011 2.527 6408945027
1.2773208945015 2.652 6808945027
1.40236089450152.7777008945027
1.52739089450152.9027408945029
1.65242089450212.9957608945029
1.77745089450213.1407908945034
1.90249089450213.2458308945034
2.02751089450213.3708608945034
2.15255089450213.4958908945034
2.27732089450273.6209208945043
2.
Installing a Crimp-On Telephone
Pulling Eye
7