Instruction Manual

ManualsBrandsCondux ManualsHardwareBreak-Away D.Drill Swivels

Figure 2. Swivel Connection

NOTE: The D.Drill

Swivel has four angular contact bearings: three for

tension loads and one for compression loads. The direction of

installation is not critical, but on

⁄8" & 1

⁄8" - 4" dia. swivels we

recommend pointing the end with a grease zerk towards the reamer.

This helps prevent dirt from getting past the seals.

1. Ensure the swivel is the correct size for the job (see Table 1), and

test the swivel operation.

2. Connect the swivel between the pulling eye and the earth packer

or reamer.

3. Tighten the clevis pin (

⁄8" - 1

⁄8" dia. swivels) or nuts and bolts

⁄8" - 4" dia. swivels) securely.

Removal is the opposite of the installation procedure.

Earth packer or reamer

Clevis Pin (

⁄8" - 1

⁄8")

or Nuts & Bolts (1

⁄8" - 4")

Pulling Eye

Installation Procedure

7/8 (22mm) Break Away Swivels

Swivel

Part No

Break Load Replacement Pin

LBS N Part No Color

08021015 150 667 08018105 SLATE/VIOLET

08021020 200 890 08018305 GREEN/ORANGE

08021025 250 1112 08018005 BLUE/WHITE

08021030 300 1334 08017605 BROWN/RED

08021035 350 1557 08018405 BLACK/GREEN

08021040 400 1779 08075305 BLUE/BLACK

08021045 450 2002 08015805 BLUE/YELLOW

08021050 500 2224 08076505 ORANGE/RED

08021055 550 2447 08018505 BLUE/GREEN

08021060 600 2669 08015005 ORANGE/BLACK

08021065 650 2891 08018605 SLATE/GREEN

08021070 700 3114 08076005 ORANGE/WHITE

08021075 750 3336 08075505 ORANGE/VIOLET

08021080 800 3559 08018705 RED/YELLOW

08021085 850 3781 08018805 BLACK/YELLOW

08021090 900 4003 08076605 ORANGE/YELLOW

08021100 1000 4448 08015705 GREEN/WHITE

08021110 1100 4893 08018905 WHITE/YELLOW

08021120 1200 5338 08015205 BROWN/WHITE

08021130 1300 5783 08019105 BROWN/YELLOW

08021140 1400 6228 08074605 GREEN/RED

08021150 1500 6672 08076905 GREEN/YELLOW

08021160 1600 7117 08019205 BLACK/WHITE

08021170 1700 7562 08019305 RED/WHITE

08021180 1800 8007 08017705 BROWN/BLACK

Table 2