Owner's manual

Configuration and Calibration 27
Port 1 Duplex Modify Menu
Table 5-15 outlines the parameters of the Port 1 Duplex Modify menu.
LED Display Alpha-Numeric Display Key Pressed Remarks
PORT 1 MODIFY DOWN arrow Enters Modify menu
PORT 1 PTR OFF UP or DOWN
arrow
Press LEFT or RIGHT arrow keys to
change the current state of the selection.
PTR OFF or PTR ON
PORT 1 CONT OFF Press LEFT or RIGHT arrow keys to
change the current state of the selection.
CONT OFF or CONT ON
DELAY 1 AUTO
(if either PTR or CONT is ON)
Press LEFT or RIGHT arrow keys to
change the current state of the selection.
1/SEC, 2/SEC, 3/SEC, 4/SEC, 5/SEC or
AUTO
T-D1 OFF
(if either PTR or CONT is ON)
Press LEFT or RIGHT arrow keys to
change the current state of the selection.
ON LINE, ABOVE, BELOW or OFF
DATA 1 DISPLAY
(if either PTR or CONT is ON)
Press LEFT or RIGHT arrow keys to
change the current state of the selection.
DISPLAY or G/T/N
EOL 1 CR/LF
(if either PTR or CONT is ON)
Press LEFT or RIGHT arrow keys to
change the current state of the selection.
CR/LF or CR
SOT 1 STX
(if either PTR or CONT is ON)
Press LEFT or RIGHT arrow keys to
change the current state of the selection.
NONE, SOH or STX
EOT 1 NONE
(if either PTR or CONT is ON)
Press LEFT or RIGHT arrow keys to
change the current state of the selection.
EOT, ETX, FF, LF or NONE
CHECK NONE Press LEFT or RIGHT arrow keys to
change the current state of the selection.
NONE, XOR or CHECKSUM
RESP ACK/NAK Press LEFT or RIGHT arrow keys to
change the current state of the selection.
ECHO, ACK/NAK or NONE
PORT 1 EXIT ? YES key Return to menu SET-UP/PORT 1 ?. See
Table 5-10 on page 24.
NO key Return to menu PORT 1/DUPLEX. See
Table 5-14 on page 26.
Table 5-15. Port 1 Duplex Modify Parameters