Owner's manual

Configuration and Calibration 23

Figure 5-9. Set-Up Mode Selection

5.13 I/O Set-Up Mode Selection

Method 1

I/O (SELECT) - See Section 5.4 on page 13.

Method 2

I/O (DIRECT) - Closing only rocker switch position

3 on switch S1 only places the indicator directly into the I/O

mode. See Section 5.3 on page 12.

The I/O SET-UP mode accesses the conﬁguration of available inputs and outputs in the DLR. There are ﬁve main

groups of conﬁgurable inputs and outputs that are deﬁned as follows:

• Serial I/O - conﬁgures ports 1 and 2 for baud rate, parity, continuous or demand, etc.

•Time and date - sets the onboard clock for time and date (allows time and date to be transmitted in the

serial output).

•Parallel output - conﬁgures DLR3110 for BCD output. This is an option requiring the installation of the

parallel output option board.

•Analog output - conﬁgures DLR3110 for analog output (4-20 mA or 0-10 VDC). This is an option

requiring the installation of the analog output option board.

•Discrete input and outputs - conﬁgures two discretes to function as either control output(s) or remote

command input(s).

Press

UP or DOWN arrow keys to step through selections. Press LEFT or RIGHT arrow keys to change the current

state of the selection. The modes may be exited at any time by pressing the

CE key. If the CE key is pressed, the

prompt

Exit? YES or NO scrolls continuously until the YES or NO key is pressed.

I/O ?

ZERO

DISPLAY

TARE PRINT

YES

CE ENTER