Owner's manual

ManualsBrandsCondec ManualsEquipmentDLR3110

Configuration and Calibration 21

5.11 Conﬁguration Set-Up Mode Selection

To access Conﬁguration mode, see Section 5.4 on page 13. Press UP and DOWN arrow keys to step through and

select parameters. Press

LEFT or RIGHT arrow keys to change the current conﬁguration of the selected parameter.

The Conﬁguration mode may be exited at anytime by pressing the

CE key. If the CE key is pressed the prompt

Exit? YES or NO scrolls continuously until the YES or NO key is pressed. See Figure 5-7 on page 20 for an

example of the DLR3110’s display.

* Represent existing data.

** Requires activation by an input. See Section 5.13 on page 23.

LED Display Alpha-Numeric Display Key Pressed Remarks

SET-UP CONFIG ? YES key Will enter CONFIG menu

XXX* FILTER 5 UP or DOWN

arrow

Press LEFT or RIGHT arrow keys to

change the current conﬁguration of the

selected parameter. 1 to 10 by 1; 10 to 20

by 2; 20 to 50 by 5.

AUTO DISP/SEC UP or DOWN

arrow

Press LEFT or RIGHT arrow keys to

change the current conﬁguration of the

selected parameter. AUTO, 2, 3 or 5

OFF ZERO % Press LEFT or RIGHT arrow keys to

change the current conﬁguration of the

selected parameter. OFF, 0.5, 1, 2, 5 or

100

Full ZERO +/- % Press LEFT or RIGHT arrow keys to

change the current conﬁguration of the

selected parameter. Full, 0.05, 0.1, 0.2,

0.5, 1 or 1.5

OFF AZM +/- Press LEFT or RIGHT arrow keys to

change the current conﬁguration of the

selected parameter. OFF, 0.5, 1, 3, 5 or 10

OFF MOTION Press LEFT or RIGHT arrow keys to

change the current conﬁguration of the

selected parameter. OFF, 1, 3, 5, 10, 20 or

50

OFF ZERO SET Press LEFT or RIGHT arrow keys to

change the current conﬁguration of the

selected parameter. OFF, Auto.tr or

OFFSET

OFF MIN Press LEFT or RIGHT arrow keys to

change the current conﬁguration of the

selected parameter. OFF or ON

OFF MAX Press LEFT or RIGHT arrow keys to

change the current conﬁguration of the

selected parameter. OFF or ON

OFF FREEZE **Press LEFT or RIGHT arrow keys to

change the current conﬁguration of the

selected parameter. 1 sec to 10 sec by 1

SET-UP EXIT ? YES key Return to MAIN menu SET-UP/CONFIG.

See Section 5.4 on page 13.

NO key Return to XXX/FILTER 5 ?

Table 5-9. Conﬁguration Mode Parameters