Owner's manual

Configuration and Calibration 13
Figure 5-2. Rocker Switch S1 Location
5.4 Main Set-Up Mode Menu Selections
Enter the main setup mode by closing switch 1 of S1 located on the main board (see Section 5.3 on page 12). All
other switch positions on
S1 must be open. To save the changes and leave MAIN set-up, open switch 1 of S1.
Press
YES key to accept selections, NO key to reject.
Mode
Switch Position
1 2 3 4
Normal Closed Open Open Open
Main set-up Open Closed Open Open
Calibration Open Open Closed Open
Diagnostic Open Open Open Closed
Table 5-1. Mode Selection Switch Modes
LED Display Alpha-Numeric Display Key Pressed Remarks
SET AUTO ? YES key See Section 5.5 on page 14
NO key Continue to CONFIG?
SET-UP CONFIG ? YES key See Section 5.11 on page 21
NO key Continue to CAL?
---- CAL ? YES key See Section 5.6.1 on page 17
NO key Continue to I/O?
SET-UP I/O ? YES key See Table 5-10 on page 24
NO key Continue to CONV?
SET-UP CONV. ? YES key See Section 5.12 on page 22
NO key Return to AUTO?
Table 5-2. Main Set-Up Mode Selection Parameters
C4
+
C14
J5
1
U1
EXPANDER
10
C8
CR7
C6
R2
1
R3
+
11
C5
C7
C10
C22
+
1
R4
U2
+
E15
U14
C31
R20
C20
U8
20
J1
KEYBD
U20
C35
C18
U6
U7
U5
C37
C17
MAIN
CAL
I/O
DIAG
RP1
DISP
R7
5
10
S1
6
MODE
J4
1
R6
1
MODE
S1
DIAG
I/O
CAL
MAIN
OPEN
12 43
FRONT OF DLR3110